19
• Place the unit on the pallet on its
back.
• Attach the Leg Adaptor Plate to
the bottom of the unit using the
supplied screws
• 1700 Only: Attach the air channel
box to the front of the pedestal
spacer using two (2) T-20 screws
• Remove the rear two provided
Leg Box bolts, slide the Leg Box
assembly over the front bolts
located on the base of the unit, and
reinstall the rear bolts thru the Leg
Box holes and tighten all four (4)
bolts.
• Carefully remove the cast iron legs
from the packaging and secure each
leg with two (2) bolts provided.
• Secure all four (4) legs, push the
leg towards the center of the stove
Note: Pre-installed on 1200
Figure 14: Installing Legs and Ash Pan Assembly.
Installation
L
EGS
A
ND
A
SH
P
AN
I
NSTALLATION
- F
REESTANDING
:
Chimney Connector
Heat Shield
Loosen screws
Flue
The heat
-effi ciency shield is installed to lower the
clearances to combustibles on the fl at top freestanding
model.
1. The unit must be in position for the installation and
with the venting ready to be assembled.
2. Loosen the two (2) top screws on the back of the
unit using a
5
/
16
” socket.
3. Place the heat-effi ciency shield on top of unit.
4. Slide chimney connector through the heat-
effi ciency shield and over the fl ue.
5. Lift the heat-effi ciency shield and screw the
chimney connector to the fl ue.
6. Slide the heat-effi ciency shield down and hook the
slot at the back of the shield, around the loosened
screws at the back of the unit.
7. Tighten the two (2) screws at the back.
Figure 15: Installing Heat Shield.
and align the legs with the outer edges of the fi rebox.
• Stand the unit on the legs and set the unit in the location ready for installation.
I
NSTALLATION
O
F
H
EAT
-E
FFICIENCY
S
HIELD
- F
REESTANDING
F
LAT
T
OP
:
