Enviro G42L, Руководство пользователя

Страница: 10 / 57

10
Maintenance And Service
R
outine
m
aintenance
:
Run through the following procedures to ensure the system is clean and working properly at least once
a year. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not
blocked by anything. The pilot flame should be blue with little or no yellow tips.
WARNING: Failure to position parts in accordance with this manual, or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
The venting system must be periodically examined; it is recommended the examination is done by a
qualified agency.
c
LeaninG
t
he
G
Lass
:
With the fireplace cooled , remove the surround panel and glass door (See M
aIntenance
a
nD
s
erVIce
-
s
urrounD
P
anel
r
eMoVal
and M
aIntenance
a
nD
s
erVIce
- G
lass
D
oor
r
eMoVal
). Check the gasket material
on the back of the glass, making sure that it is attached and intact.
During a cold start up, condensation will sometimes form on the glass. This is a normal condition with
all gas fireplaces. This condensation can allow dust and lint to cling to the glass surface which requires
periodic cleaning.
Initial paint curing of the appliance can leave a slight film behind the glass, a temporary problem. The
glass will need cleaning about two weeks after installation.
Use a mild glass cleaner and a soft cloth . Abrasive cleaners will damage the glass and painted
surfaces. Depending on the amount of use, the glass should require cleaning no more than two or three
times a season.
WARNING:
Do not clean the glass when it is hot.
c
LeaninG
t
he
F
iRebox
:
Carefully remove the logs, they are fragile. Gently remove all the media and place on a paper towel.
Vacuum the bottom of the firebox thoroughly. Carefully clean any dust off the logs and remove any
lint from the burner and pilot. At this time, inspect the burner tube for cracking or severe warping. If
a problem is suspected, contact the dealer. Check the logs for deterioration or large amounts of soot;
a small amount on the bottom side of the logs is normal. Replace the logs as shown in the s
econDary
I
nstallatIon
- l
oG
s
et
I
nstallatIon
section. If new/more media is required, contact your nearest ENVIRO
dealer.
R
ePLacinG the
G
Lass
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see P
arts
l
Ist
). Wear gloves when handling damaged glass door assembly
to prevent personal injury. Do not operate with the glass front removed, cracked or broken. Removal
and replacement of the glass from the door must be done by a licensed or qualified service person.
The glass must be purchased from an ENVIRO dealer. No substitute materials are allowed.
To remove the door (see M
aIntenance
a
nD
s
erVIce
- G
lass
D
oor
r
eMoVal
) . The replacement glass will
come with a new gasket installed. Remove any silicone remnants from the door. Apply high temperature
around the perimeter of the door and install the new piece of glass with gasket. Apply even pressure to
the glass to allow the silicone to adhere to the gasket material.