Enviro EF-V EVOLUTION, Техническое руководство

Страница: 29 / 34

29
8. The stove will not shut down
- Check the connections to the 120
°
F (49
°
C) exhaust temperature sensor, start-up switch
and the start-up timer against the wiring diagram.
- Check the 120
°
F (49
°
C) temperature sensor by removing one of the brown wires from
the sensor. The unit should shut down right away as long as the start button was not
pressed within 15 minutes of this test. If the stove shuts down within 15 minutes,
replace the 120
°
F (49
°
C) sensor. If the stove does not shut down within 15 minutes, test
the switch.
- To test the switch, the stove must be cold. Pull the plug, then plug the stove back in. If
the fails to start, Replace the switch.
9. The stove keeps going out
- If the stove goes out and leaves fresh unburned pellets or cigarette-like ashes in the
burn pot liner, the fire is going out before the 120
°
F (49
°
C) temperature sensor shuts the
stove off.
- Check to see that the slider is in the correct position.
- Turn the Dial-a-Fire up slightly (poor quality pellets will require slightly higher
settings).
- If the stove goes out and there are partially burned pellets left in the burn pot liner, the
stove shuts down due to a lack of air, exhaust temperature or power failure.
- Adjust the slider damper.
- Check to see if the stove needs a more complete cleaning.
- Turn the Dial-a-Fire up slightly (poor quality pellets will require slightly higher
settings).
- Did the power go out?
- If the stove goes out and there are no pellets in the liner, the auger is stopping.
- See “The auger motor will not function normally” and “The exhaust blower will not
function normally.”
10. Thermostat Interface does not work correctly
- Make sure that the thermostat is calling for heat
- Make sure that the Dial-A-Fire is set to the desired setting.
- Make sure of all electrical connections at the thermostat and the thermostat
Interface.
- Remove the two thermostat wires from the thermostat Interface and place a jumper
over the two thermostat interface pins, Control with Dial-A-Fire should be restored,
If not replace the Thermostat Interface.
-
If control comes back to the unit check, Continuity at the thermostat connections
and Thermostat wires.
-
Replace the thermostat.