12. PARTS AND ACCESSORIES
Service Parts available from your local Envirogas Dealer
Burner Control Assembly
Convection Blower
Natural Gas Pilot Assembly
Light Bulb Holder
Propane Pilot Assembly
Light Switch (momentary)
Door Bolt
Fan Controller
Relief Door Gasket
Log Set (with Embers)
Regulating Valve
Thermocouple
Piezo Igniter
Embers
Burner Switch
Thermopile
Door Gasket
B-vent Spill switch 300
°
F(149
°
C) MR.
Convection Fan Sensor 120 F (49C)
Orifice Blank
Accessories
Gold trim Package
Low Voltage Thermostat
REMOVING or LUBRICATING THE BLOWER
The blower should be lubricated every 12
mos.
1. Turn the unit off and remove the log set.
2. Remove the burner tray assembly by removing
the screw on either side of the tray, between the
front and rear burners. Lift the tray out. Remove
the brick liner by undoing the screw on either
side and sliding the panel out.
3. Remove the 4-5/16” bolts that hold the blower
mounting plate to the back firewall. Use a light
lubricating oil on screws before removal.
4. Carefully pull the blower assembly into the firebox, exposing the blower lubricating holes (located on the top of the
motor housing on either side of the label). Add 2 drops of SAE 20 oil.
5. If removal of the blower is necessary, disconnect the blower leads from the harness. Remove the blower.
6. To re-install, check mounting plate gasket and reverse steps 1 through 4.
16
