7.
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A)
This appliance is equipped with a pilot, which
must be lit by hand by following these
instructions exactly.
B)
BEFORE LIGHTING smell all around the appliance
area for gas, and next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not
use any phone in your building.
•
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
•
If you cannot reach your gas supplier, call
the fire department.
C)
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, do not try to repair
it . Call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D)
Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas
control which has been under water
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information above.
2.
Turn off all electrical power to the appliance.
3.
Turn the gas control knob
clockwise to the “off’ position.
4.
Open door.
Wait five (5) minutes to clear out
any gas
. Close door. If you smell gas including
near the floor,
STOP!
Follow “B” in the above
safety information.
If you don’t smell gas go to next step.
5.
Find the pilot located to the right between the
front and rear burner.
6.
Turn gas control knob counter-clockwise to
“PILOT”.
7.
Push the gas control
knob in
fully and hold. Immediately light the pilot by
pushing the piezo spark igniter. Keep knob
depressed for about 30 seconds after pilot is lit.
Release knob. If pilot goes out, repeat steps 4
through 6.
WARNING; The gas valve has a lockout device,
which will not allow the pilot burner to be re-lit
until the thermocouple, has cooled.
If the knob does not pop up when released, stop
and immediately call your service technician or
gas supplier.
NOTE: Check to be sure the pilot flame engulfs the
thermocouple
and that the burners light
completely.
If the pilot will not
stay lit after
several tries, turn
the gas control
knob to “OFF" and
call you service
technician or gas
supplier.
HI \ LO knob
Control knob
Turn gas control knob counter-clockwise to the
“ON” position.
Flip burner switch to “ON”
then turn “HI / LO” knob to the desired setting.
8.
Turn on all electrical power to the unit
TO TURN OFF GAS TO
APPLIANCE
1.
Turn the gas control knob
clockwise to “OFF” DO NOT FORCE
12
