8. ROUTINE MAINTENANCE
Periodically check to ensure that the "B-Vent" venting
system is clear and that a negative draft is present
when the unit is operating.
open door fully
•
Lift door vertically so that the hinge pins lift out
of hinge receivers.
•
R
eturn assembly to dealer.
Periodically check the pilot and burner flames
Your ENVIROGAS Dealer must replace door and glass
assembly as a complete unit. No substitute materials
are allowed
.
CLEANING OF GLASS
Do not clean glass when hot
FOR CLEANING THE INSIDE OF THE
FIREBOX
It will be necessary to clean the ceramic glass
periodically. During a cold start up condensation will
sometimes form on the glass, this is a normal
condition with all gas fireplaces and stoves. However,
sometimes this condensation can allow dust and lint
to cling to the glass surface. Also, sometimes the
initial paint curing of the appliance can leave behind a
slight film on the glass. This is a temporary problem.
It is therefore recommended that the glass be cleaned
initially after about the first two weeks of use.
Remove the log set carefully from the firebox. Gently
remove the embers and place on a piece of paper
towel. Until ready to replace.
Vacuum the firebox thoroughly. Carefully clean off
any dust on the logs and remove any lint from the
main burner and pilot burner.
After carefully replacing the logs and embers in their
correct positions, and the door has been resealed, re-
light the pilot, following the instructions on the
attached label.
After that, depending upon the amount of use,
cleaning should be required no more than two or
three times per season.
To clean the door, use a mild glass cleaner and a soft
cloth. Abrasive cleaners will damage the glass
surface.
CLEARANCES MUST BE SUFFICIENT TO ALLOW
ACCESS FOR MAINTENANCE AND SERVICE
LUBRICATING THE BLOWERS
OPENING THE GLASS DOOR
EVERY 6 MONTHS
Turn unit off and wait until the appliance has cooled
down.
1. Turn the unit off and remove the log set.
1. Open the right hand hinged side flap that will
expose a door fastener. Using a 1/2" wrench, loosen
off the fastener.
2. Remove the burner tray assembly by removing the
screw on either side of the tray, between the front
and rear burners. Lift tray out.
2. Due to the shape of the bay window door. You
must also open the left-hand side flap before
attempting to open the Bay window door.
3. Remove the 8 screws that hold the blower
mounting plate to the back firewall.
4. Carefully pull the blower assembly into the
firebox, exposing the blower lubricating holes (located
on the top of the motor housing on either side of the
label). Add 2 drops of SAE 20 oil.
3. Ensure the door is properly fastened after cleaning
before attempting to re-light the appliance.
4. Remove all fingerprints from all gold before
lighting this appliance.
If removal of the blower is necessary, disconnect the
2 black blower leads from the terminal block, located
on the floor of the fan compartment. Remove the
blower.
TO REPLACE DOOR AND GLASS
ASSEMBLY
The glass in this appliance is an integral part of the
door assembly. If the glass is damaged or broken a
replacement door assembly including glass must be
fitted.
5. To re-install, check gasket and reverse steps 1
through 4.
10
