User Manual
50657 (PIXELATOR)
www.enttec.com
US Patent Patenting
ID: 2114
5
Web: Profile Editor
Create a new profile or edit an existing one using the
profile-editor. Profile Editor opens in a new page in your
web browser. Select a module on the left and the right
panel will provide help about that panel. Connect a
module to another using wires from one point to another.
The direction of the wire (arrow) is important, the arrow
signifies output, and reflects the flow of data.
Web: Profile Modules
Each profile is made up of two or more connected
Modules or Actions. The relationship between them
forms the layout of the data flow within the profile.
The following modules are available:
The
PLink 1U
module represents one of the physical
ports on the rear of this unit, and maps to 1 Universe.
•
Protocol: select the led protocol that the pixel
tape conforms to.
•
Ordering: RGB or RGBW mapping that the pixel
tape conforms to. RGB modes use 3 DMX slots per
LED pixel, and RGBW modes use 4 DMX slots.
•
Grouping: it allows one DMX pixel to drive
multiple physical LED pixels
•
Start-Ch: DMX Start Channel for the 1
st
pixel can
be changed as needed.
Limitation
: Same PLink port# cannot be re-used within
the same profile
The
PLink 2U
module represents one of the physical
ports on the rear of this unit, and maps to 2 Universe.
•
Each PLink 2U module has 2 input nodes that can
be connected to two Ethernet streams. Top one
(U1) is mapped to the First universe and Bottom
one (U2) is mapped to the Second universe
relative to the pixel-tape.
•
Protocol: select the led protocol that the pixel
tape conforms to.
•
Ordering: RGB or RGBW mapping that the pixel
tape conforms to.
Limitation
: Same PLink port# cannot be re-used within
the same profile
Art-Net Stream:
"Send IP address": is the destination
address used when the stream is sending data only.
ESP Stream
: ENTTEC Show protocol DMX over Ethernet
stream (ESP).
IP address is the destination address used when the
stream is sending data only.
Kinet Stream
: For example: You can connect Kinet Stream
to an Art-Net Stream to convert and output as Art-Net. (Kinet
stream is supported as input only)
.
Streaming ACN
: "IP address" is the destination address
used when the stream is sending data only
(default is disabled = 0.0.0.0)
DMX Generator
: Define your own custom DMX Channel
values and assign the selected ones.
Snapshot feature can be used to capture values from an
input stream. All modifications can be done using the
DMX Grid Page.
