User Manual
50657 (PIXELATOR)
www.enttec.com
US Patent Patenting
ID: 2114
6
Clock:
Allows you to synchronize ALL Pixel Link output
only when the connected Input Stream is received.
•
Auto-repeat allows user to repeat the output
once every "number of seconds" regardless of
Synced Stream
•
Default behavior [Auto-repeat = Never]: Will only
refresh Pixe Link when Synced Stream is received
The Clock module can be used to make sure the output is
always synced to the “latest universe” - especially if the
source adds a delay to each universe.
Firmware Update
You can update the firmware on the Pixelator, via the
web browser. Get the new firmware files (they are
available on website: www.enttec.com/Pixelator).
Download them to your desktop and then follow
instructions in the Pixelator's web browser page,
under the Settings section.
Note: While the firmware is being updated, please do
not power off the unit, please wait until the web-page
is processing. (up-to 5 minutes).If the web-page does
not refresh automatically, please open the home page
on the browser manually, and verify that the update
has succeeded.
NMU
NMU (Node Management Utility) is a free Windows and
Mac application that is used to manage compatible
ENTTEC DMX over Ethernet nodes. NMU will not directly
allow you to configure the Pixelator itself, but it can help
you find your unit's IP address and then open a browser
window to access Pixelator. Follow these steps:
1.
Download NMU from www.enttec.com/nmu
2.
Ensure that your Pixelator is hooked up physically
by Ethernet cable to the same physical network as
the computer on which you will run the NMU.
3.
Press the Discovery button.
4.
Once found, select Pixelator and use the IP address
to access the web interface via your web browser.
