Streamer Utilities
31
The
Timing
selection box allocates a timing method to the selected Event.
Looped Auto Play
The Show will start at a specified time, loop for the programmed number of repetitions and then stop.
The Event's start time and the number of loop repetitions must be entered.
Timed Auto Play
The Show starts at a specified time and loops continuously until a specified finish time.
The Event's start time and end time must be entered.
Power ON
The Show will start when the DMXStreamer has completed its power-up sequence, loop for the programmed
number of repetitions and then stop.
The number of loop repetitions must be entered.
Switch Closed
The Show will start when an electrical connection is made between Pin 4 (Switch) and Pin 1 (Ground) of the
DMX Input connector, on the back panel of the DMXStreamer. It will loop for the programmed number of
repetitions and then stop.
A switch closure Show preempts any Event currently running.
The number of loop repetitions must be entered.
Remote Command
The Show will start on a command received through the RS232 serial data link from such sources as a
DMXPlayBackRemote, or any custom-programmed RS232 transmitting device. It will loop for the
programmed number of repetitions and then stop.
(See
RS232 Commands supported by the DMXStreamer
on page
50 for more details.)
The number of loop repetitions must be entered.
Loop
The
Loop
selection box sets the number of times that the selected Show will be repeated. A show may be
repeated a fixed number of times before ending [0-100], or set to repeat forever.
Looping zero times means that the Show runs only once.
Event Start / End Time
