Entryvue 13507, Руководство пользователя, Страница: 7 / 11

Bit-1 to Bit-5 are used for User Code setting.The DT596 responds to 0~15 .
5. DIP Switch Setting
-11- -10-
5.1 DIP Switch Settings of Door Station
6. Functions Setting Up
5.2 DIP Switches Settings of Monitor
ON(1)
=
OFF(0)
=
ON ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
Total 4 bits on the DIP switches can be configured.The switches can be modified either before or after installation.
Setting Item Bit State Descriptions
Bit1 and Bit2
(it is used to set
the ID code for
door station)
Default setting, ID = 0(00), set to the first Door Station.
ID = 1(10), set to the second Door Station.
ID = 2(01), set to the third Door Station.
ID = 3(11), set to the fourth Door Station.
Bit3
Bit4
Activate external output setting,the relay 2 terminal doesn't
respond to the second lock and will be closed for 60 seconds
when the "Lockout" is carried out.The alarm connected to
the terminal of relay 2 will be activated.
inactivate
Reserve
There are 6 bit switches in total. The DIP switches are used to configure the User Code for each Monitor.
Bit-6 is line terminal switch, which needs to be set to ON if the Monitor is in the end of the bus, otherwise set to OFF.
Bit state Setting Bit state Setting
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
The monitor is
not at the end
of the bus.
The monitor is
at the end of
the bus.
BIT STATE USER CODE BIT STATE USER CODE BIT STATE USER CODE
Code=0 Code=6 Code=11
Code=1 Code=7 Code=12
Code=2 Code=8 Code=13
Code=3 Code=9 Code=14
Code=4 Code=10 Code=15
Code=5
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON

This section explains the settings of each function,please refer to the following table:
About the setting mode:
Input the master code to switch the setting mode, and input the corresponding setting code to perform the
the function you want. After settings have been made, input the following setting codes to continue the setting
operation. Press "
*
" to exit the setting mode.
• The example is set as cancel button and # as confirm button,please refer to */# function setting
for detail information.
• No slide-touching the digital keypad,it may cause mistaken recognition of keys being pressed,
the correct operation is using your finger to press the digit you desired.
• You should press“confirm”button after finish inputting the code number each time,otherwise,
the operation will be cancelled automatically in 10s.