10
Set the number of days that you would like to calculate your average glucose.
The number of days can range from 1 to 99 days. To increase or decrease
the number of days, press the or arrows. You have three options to set
the number of days. The meter default settings are 7 days, 14 and 21 days.
Precaution
1. Your BLE Smart Meter is pre-set to measure in mg/dL by default. If
you need your meter set to another unit of measure (mmol/L), please
contact Customer Support. USA & Canada: +1-877-458-2646.
International: +1-619-684-6232 or email [email protected]
2. If the Date is not set properly, the average glucose test results in the
memory will not calculate the proper values. It is recommended you
set up the glucose meter before you use it and when new batteries are
installed.
3. Blood glucose testing cannot be performed while in Set-up mode.
4. To turn the meter off during the set up, press and hold for 5 seconds
or until the meter beeps.
Alarm time
Use the
or buttons to
set the alarm hour
and minute, confirm
by pressing .
Alarm
After programming
the number of
desired alarms
(5 alarms are
available), exit set-
up by pressing .
Strip Eject
Select ON to activate test
strip eject transmit. Confirm
by pressing .
SEnd
Alarm on / off
Use the or
buttons to turn
the alarm on/off.
Confirm by pressing
ajks
.
