Enterasys SECURESTACK C3, Руководство по настройке

Страница: 860 / 872

sFlow Configuration clear sflow port poller
28-12
clear sflow port poller
Use this command to change the poller interval or to remove poller instances.
Syntax
clear sflow port port-string poller [ interval ]
Parameters
Defaults
If interval is not specified, the poller instance is cleared.
Mode
Switch command, read ‐ write.
Example
This example removes the poller instance on port ge.1.1.
C3(su)->clear sflow port ge.1.1 poller
set sflow port sampler
Use this command to configure sampler instances on ports, or data sources.
Syntax
set sflow port port-string sampler { index | maxheadersize bytes | rate rate }
Parameters
port ‐ string Specifies the port or ports on which the poller instance is being cleared.
interval (Optional) Specifies that the polling interval should be cleared to 0. A
value of 0 disables counter sampling.
port ‐ string Specifies the port or ports (data sources) on which the sampler instance
is being configured.
index Index number in the sFlow Receivers Table for the receiver/Collector
with which the sampler instance is associated. The index can range from
1 to 8.
maxheadersize bytes Specifies the maximum number of bytes that should be copied from the
sampler packet. The value can range from 20 to 256 bytes. The default is
128 bytes.
rate rate Specifies the statistical sampling rate for sampling from this data
source. The value of rate specifies the number of incoming packets from
which one packet will be sampled. For example, if the rate is 1024, one
packet will be sampled from every 1024 ingressing packets on this data
source.
The rate can range from 1024 to 65536. A value of 0 disables sampling.
The default value is 0.