Enterasys SECURESTACK C3, Руководство по настройке

Страница: 471 / 872

set rmon event status
SecureStack C3 Configuration Guide 15-15
Example
This example shows how to create and enable an RMON event entry called “STP topology
change” that will send both a log entry and an SNMP trap message to the “public” community:
C3(rw)->set rmon event properties 2 description "STP topology change" type both
community public owner Manager
set rmon event status
Use this command to enable an RMON event entry. An event entry describes the parameters of an
RMON event that can be triggered. Events can be fired by RMON alarms and can be configured to
create a log entry, generate a trap, or both.
Syntax
set rmon event status index enable
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Usage
An RMON event entry can be created using this command, configured using the set rmon event
properties command ( “set rmon event properties” on page 15 ‐ 14 ), then enabled using this
command. An RMON event entry can be created and configured at the same time by specifying an
unused index with the set rmon event properties command.
Example
This example shows how to enable RMON event entry 1:
C3(rw)->set rmon event status 1 enable
clear rmon event
Use this command to delete an RMON event entry and any associated log entries.
Syntax
clear rmon event index
Parameters
index Specifies an index number for this entry. Maximum number of entries is
100. Maximum value is 65535 .
enable Enables this event entry.
index Specifies the index number of the entry to be cleared.