Enterasys Matrix 7GR4202-30, Руководство по установке оборудования

Страница: 51 / 86

Connecting to COM Port for Local Management
Matrix DFE-Diamond Series Installation Guide 3-21
5. When these parameters are set, the Local Management password screen will display. Refer to
the appropriate Enterasys Matrix DFE ‐ Diamond/Platinum Series Configuration Guide for further
information.
Figure 3-15 Connecting an IBM PC or Compatible
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks DFE module COM port ( Figure 3 ‐ 16 ),
use a UTP straight ‐ through cable with RJ45 connectors and an RJ45 ‐ to ‐ DB25 female adapter, and
proceed as follows:
1. Connect the RJ45 connector at one end of the UTP straight ‐ through cable to the COM port on
the Enterasys Networks module.
2. Plug the RJ45 connector at the other end of the UTP straight ‐ through cable into the RJ45 ‐ to ‐
DB25 female adapter.
3. Connect the RJ45 ‐ to ‐ DB25 adapter to the port labeled COMM on the VT terminal.
4. Turn on the terminal to access the Setup Directory and set the following parameters:
When these parameters are set, the Local Management password screen will display. Refer to the
Enterasys Matrix DFE ‐ Diamond/Platinum Series Configuration Guide for further information.
1 UTP straight-through cable with RJ45 connectors 3 RJ45-to-DB9 PC adapter
2 RJ45 COM port 4 IBM PC or compatible device
7GR4280-19
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit