Enterasys IRM2, Руководство пользователя

Страница: 78 / 88

Redundancy
7-6 Establishing Redundancy
Setting the Polling Interval and Number of Retries
Once you have configured your redundant circuits, you can set the parameters
that the IRM2 uses to monitor them, including the interval (in seconds) between
polls of the physical addresses on your Polling Addresses list, and the number of
times to retry polling for each circuit.
To test each enabled circuit, the IRM2 polls each address in the Polling Addresses
list simultaneously, then waits the number of seconds set in the Polling Interval
field for a reply. If at least one reply is received during the polling interval, the
IRM2 simply polls all addresses again at the end of the interval. If no reply is
received during the polling interval, the IRM2 will continue polling for the
number of retries set for each circuit; if at least one reply is received during a retry,
polling continues. If no replies are received during the retries, the IRM2 will
assume the primary link is down, and switch traffic to the first backup port.
To establish the polling interval for all circuits:
1. Click on the gray button to the right of the Polling Interval field in the upper
right-hand corner of the Redundancy Configuration window; the Polling
Interval window,
Figure 7-5 , will appear.
Figure 7-5. Polling Interval Window
2. Type in the number of seconds you want between polls to the network
addresses listed for each enabled circuit. The range is 0–99 seconds; the
default value is 3.
3. Click on to set the new polling interval, or on Cancel to close the
window without making any changes. Note that the polling interval you set
here will be applied to
all
active circuits; you cannot set individual polling
intervals.
To establish the number of retries for the designated circuit:
1. Click on Configure to display the circuit configuration menu; drag down to
Retry Count, and release. The Retry Count window,
Figure 7-6 , will appear.
Figure 7-6. Retry Count Window