ENSONIQ ESQ-M, Руководство музыканта, Страница: 32 / 118

31
MIDI Page
ESQ-M – Musician's Manual
----> PEDAL=VOL — When PEDAL=VOL the Foot Pedal will adjust the volume of the current
Track. Moving the Pedal will have the same effect as adjusting the MIX Level on the MIDI
Page. Only the current Track will be affected — only one Tracks volume can be adjusted
at a
time.
3. BEND RANGE — Pitch Bend Wheel Range
Adjusts how far incoming Pitch Bend information (transmitted by the Pitch Bend Wheel on
most keyboards) will bend a note Up or Down. Each increment represents a Semitone. Total
range is one octave up an down.
Range:
0 To 12.
4. BNDTYP — Pitch Bend Type (or mode) Selects between two modes of operation
for the Pitch Bend Wheel. There are two Modes:
ALL — Moving the Pitch Bend Wheel will affect the pitch of all notes that are being played.
This is how most Pitch Wheels usually operate.
HELD — In this Mode,
only those keys that are being held down
when you move the Pitch
Wheel will be affected by the wheel. Keys that have been released will not bend, even if they
are being sustained by holding down the Sustain Foot Switch. This enables you to bend certain
notes while others remain unchanged in pitch. With a little practice you can simulate guitar and
pedal steel-type techniques, and many other interesting effects.
Note that the ESQ-M must be enabled (on the MIDI Page) to receive Controllers, or else
parameters 3 and 4 will have no effect, as Pitch Bend information will not be recognized. See
the following section for details on the MIDI Page.