ENSONIQ ESQ-M, Руководство музыканта

Страница: 12 / 118

Rear Panel Connections
11
ESQ-M – Musician's Manual
AUDIO OUTPUTS:
1.
RIGHT -- To operate the ESQ-M in
Stereo, connect this Output to a channel of your
Mixer and pan that channel Right. If nothing
is connected to this jack, both channels of
the ESQ-M's Output will be combined and
sent out the Left/Mono Output.
2.
LEFT/MONO -- When operating the ESQ-
M in Stereo, connect this Output to a channel of
your Mixer and pan that channel Left. To
operate the ESQ-M in Mono, use this jack
only. Again, if nothing has been connected to
the Right Output jack, the Left/Mono jack will
produce a Mono signal that is the sum of the two
channels of the E S Q - M ' s O u t p u t .
S p e c s :
( B o t h A u d i o Outputs): 1 KOhm output
impedance, DC coupled. Line level output into
10 KOhms or higher (one voice=1 Vp-p
typical; all voices= 15 Vp-p)
3.
CV/PEDAL
This jack is for connecting an optional
ENSONIQ Model SW-10 Control Voltage
F o o t P e d a l , w h i c h i s a s s i g n a b l e a s a
Modulator in the Program Section of the
ESQ–M. (Note that incoming MIDI Foot
Pedal information (MIDI Controller #4) will have
the same effect.) Or, the CV Pedal can serve as a
Volume Pedal when PEDAL=VOL is selected on
the MASTER Page.
Specs: [Pedal Input]: 3-conductor
(Tip=control voltage input, Ring=2KOhm
resistor to +12 Volts, Sleeve= ground). 500
KOhm input impedance, DC coupled. Input
voltage
range=0 to 10 volts DC. Scan
rate=5mS (maximum recommended
modulation input= 25 Hz). For use with an
external control
voltage, use a 2-conductor cable with the voltage
on the tip and the sleeve grounded.
4.
MIDI IN
Receives MIDI information from other
instruments or computers. The MIDI Output of a
MIDI keyboard or other controller must be
connected to this input with a standard Spin
MIDI cable in order for the ESQ-M to make any
sound.
5.
MIDI OUT
This jack sends out MIDI (Musical Instrument
Digital Interface) information to other
ins truments and computers . Since the
ESQ–M is primarily a receiving unit, much of
the time there won't be a reason to plug anything
into this jack. It is important mainly for sending
data, such as Program Banks, to other ESQ products
and computers.
6.
MIDI THRU
This jack "passes along" all information
received at the ESQ-M's MIDI In jack. It is used
for chaining MIDI devices together when driving
multiple instruments from a master keyboard or
sequencer.
7.
FUSE 1 amp fast-blow fuse socket.
8.
AC LINE IN
The supplied line cord should be connected
here. The correct voltage for the ESQ-M is listed
on the Serial Number label on the rear panel. If
you travel, remember that the ESQ–M will
only operate on this voltage.