EN
43
Select a space close to a mains power socket.
Make sure there are no hidden electrical cables or pipework.
Place the wall bracket in the installation position and use a pen to
mark the two drill holes.
Drill the two holes where you made your markings, so you can in-
sert the screws in them.
Push the wall plugs into the drilled holes.
Secure the wall bracket to the wall with the plug recess facing up-
wards using the two screws supplied. You can adjust the position
slightly using the slots (15).
Insert the coaxial power adapter into the wall brack-
et cable holder as shown in the illustration. When doing
so, pay attention to the recess on the plug and the guide
slot on the cable holder.
Lock the plug with a quarter turn.
PREPARATIONS FOR USE
Remove all packaging materials from the appliance and accessories.
Remove the safeguard from the on/off switch.
First, assembly the cyclone attachment (14) and the
dust filter (13). Ensure that the edge of the cyclone at-
tachment fits into the recess on the dust filter so that
the arrow markings on the edge of both parts are
aligned.
Fit the cyclone attachment with dust filter into the dust
container (1) properly so that the dust filter seal closes
the dust container. The arrow marking on the edge of
the cyclone attachment is parallel to the grooved tab at
the top of the dust container.
Place the dust container on the power base by first placing it on the latch at the bot-
tom of the power base and then close it until you hear the release button click into
place.
15
14
13
1
19400 ML Eurospin IT Content 5006 5664 Final_rev3.indb 43
19400 ML Eurospin IT Content 5006 5664 Final_rev3.indb 43
02.10.2020 09:10:18
02.10.2020 09:10:18
