39
EN
7. Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than
those specified in the operating manual may
cause a risk of injury.
Designation
Set of diamond cutting discs Ø 110 mm /
115 mm
Spare battery 4.0 Ah 20V
8. Errors and faults
The device has been checked for proper
functioning several times during production.
If malfunctions occur nonetheless, check the
device according to the following list.
Troubleshooting tasks which require the
housing to be opened must only be carried out
by an authorized specialist electrical company
or by Eurospin.
Slight smoke or odour are emitted during first
use:
•
This is not a fault. These phenomena
disappear after a brief runtime.
The battery does not charge:
•
Check whether the battery is correctly
connected to the quick charger.
Slide the battery into the quick charger in
a way that the battery terminals engage in
the quick charger. The battery must lock in
place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for
damages.
•
Check the fuse (home).
•
Check the quick charger for damages.
Should the quick charger be damaged, stop
using it. Contact the Eurospin customer
service.
•
Check the battery terminals for dirt.
Remove any dirt.
•
The battery might be defective and have to
be replaced. Only use batteries of the same
type.
The device does not start:
•
The battery power might be too low.
Recharge the battery.
•
Check whether the battery is correctly
connected to the device.
Slide the battery onto the device in a way
that the battery terminals engage. The
battery must lock in place in the device.
•
Check the battery terminals for dirt.
Remove any dirt.
Info
Wait for at least 10 minutes before switching
the device back on.
The cutting disc is loose:
•
Check whether you are using a cutting disc
that is suited for this device.
•
Make sure that the mounting flange is
firmly locked in place in the designated
recesses.
•
Make sure that the cutting disc sits flush
on the mounting flange without clearance.
•
Make sure that the flat side of the clamping
nut rests on the cutting disc.
The guard is loose:
•
Make sure that the coding pin (9) are firmly
locked in place in the designated groove.
•
Make sure that the locking lever is folded in
completely.
•
If necessary, tighten the adjusting screw.
The cutting disc does not move although the
motor is running:
•
Make sure that the clamping nut is firmly
tightened, see chapter Tool change.
•
Make sure that there is no workpiece debris
blocking the drive. Remove the blockages, if
any.
•
Make sure that the cutting disc is not
jammed in the workpiece.
Содержание 149798.01
Страница 3: ...3 8 9 7 7 10 7 10 10 11 8 7 12 14 11 13 1 11 16...
Страница 4: ...4 19 18 14 15 15 17 17 1 11 16 15 16 17 16 18 5 5...
Страница 81: ...cod articolo 149798 01...