ENKHO 149798.01, Оригинальное руководство пользователя

Страница: 36 / 81

36
EN
Never charge the battery at ambient
temperatures below 5 °C or above 50 °C.
The battery is partially charged upon delivery to
avoid damage to the battery caused by a deep
discharge.
Prior to initial start-up and when the battery
is low (only the red LED in the battery level
indication (12a) is illuminated), the battery
should be charged. To do so, please proceed as
follows:
1. Insert the battery (12) into the quick
charger (13) upside down.
2. Insert the mains plug of the quick charger
(13) into a properly fused mains socket.
- The red battery LED (21) lights up.
- Charging requires approx. one hour and
30 minutes.
3. Wait until the red battery LED (21) goes off
and the green battery LED (20) lights up.
- The battery (12) is fully charged.
4. Hold onto the mains plug while pulling the
power cable of the quick charger (13) out
of the mains socket.
- The battery (12) and the quick charger
(13) may have become warm during
charging.
Allow the battery (12) to cool down to
room temperature.
5. Remove the battery (12) from the quick
charger (13).
Inserting the battery (Fig. 3)
1. Slide the battery (12) onto the device until
it locks in place.
Removing the battery (Fig. 4)
1. Detach the battery (12) from the device by
pressing and holding the release button
(19) and pulling the battery off the device.
2. If required, charge the battery (12) as
described in the section Charging the
battery.
Checking the battery status (Fig.5)
The battery comes with an integrated battery
level indication.
The battery status is displayed as follows by the
three LEDs of the battery level indication (12a):
LED colour Meaning
Green – Orange –
Red maximum charge /
power
Orange – Red medium charge / power
Red
weak charge – Recharge
the battery.
1. Press on the battery icon (22) on the
battery (12).
- You can read the battery status from
the battery level indication (12a).
Mounting the handle
Caution
Only use the device with the supplied additional
handle.
The additional handle (14) must be mounted
before start-up. (Fig.6)
To do so, please proceed as follows:
1. Screw the additional handle (14) clockwise
into the thread (2) either on the right or left
side or on top of the housing.
2. Check the additional handle (14) for tight
fit.
3. For disassembly unscrew the additional
handle (14) counter-clockwise.
Adjusting the guard
Warning of electrical voltage
Before any work on the device, remove the
mains plug from the mains socket and the
battery from the device!
Hold onto the mains plug while pulling the
power cable out of the mains socket.
Caution
If you detect damage at the guard, stop using
the device.
The guard is preassembled.
Only use the cordless angle grinder with the
guard mounted to protect yourself and your