ENKHO 149798.01, Оригинальное руководство пользователя

Страница: 38 / 81

38
EN
6. Operation
Tips and notes on handling the cordless angle
grinder
.
General information:
• Carry out a test run of approx. 1 minute
without load prior to every disc change and
every start-up in order to check the cutting
disc for correct fit.
• Only use tools which are approved for the
device used.
• Before every application, make sure that
you have selected the correct tool for the
intended use.
• Check whether the cutting disc can rotate
freely. Make sure that the disc does not
touch the guard or other parts.
• Only use discs with a speed imprinted that
is at least as high as the speed indicated on
the device's nameplate.
• Clamp the workpiece unless it is firmly and
safely positioned by its own weight.
• Do not overload the device so that it comes
to a standstill.
• After operation at high load, let the device
run at idle for several minutes to allow the
tool to cool down.
• Do not touch the discs until they have
cooled down.
• Keep the venting slots clear to prevent the
motor from overheating.
Cutting:
• Only use intact, flawless cutting discs. Bent,
blunt or otherwise damaged cutting discs
could break.
• Never use the cutting disc for roughing!
• Only advance moderately during operation
and make sure that the cutting disc does
not get jammed.
• Do not slow down the decelerating cutting
disc by pressing against the side of the
disc.
• Always move the cutting disc through the
workpiece in reverse rotation.
Switching the device on and off (Fig. 18-19)
Wear your personal protective equipment when
working with the device.
1. Check whether the mounted cutting disc is
suitable for the intended application.
2. Check whether the workpiece is secured
and the worktop prepared correspondingly.
3. Slide back the start lock (18) at the on/off
switch (5).
4. Press the on/off switch (5) and hold it
during operation.
5. Carry out a test run of approx. 1 minute
without load prior to every disc change and
every start-up in order to check the cutting
disc for correct fit.
6. After switch-on, wait until the device has
reached its maximum speed. Only then
start working.
7. To switch the device off, let go of the on/off
switch (5).
Caution
The disc keeps running after the device has
been switched off.
Risk of injury.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp
hands.
• Switch off the device.
• Hold onto the mains plug while pulling the
power cable of the charger out of the mains
socket.
• If required, allow the device to cool down.
• Remove the battery from the device (see
Start-up chapter).
• Remove the tool from the device (see
Start-up chapter).
• Clean the device according to the
Maintenance chapter.
• Store the device according to the Storage
chapter.