England's Stove Works 25-CBPAH, Руководство по установке и эксплуатации

Страница: 17 / 103

17
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
FLOOR PROTECTION

This pellet stove requires a non ‐ combustible floor protector if the stove is to be installed on a combustible
floor. If the floor the stove is to be installed on is already non ‐ combustible (i.e. a concrete floor in a
basement) and has an R value equal to or higher than .2, no floor protection is needed (although a
decorative floor protector can still be used for aesthetic reasons).

Prefabricated floor protectors which are UL listed (ULC if Canada) or equivalent can be purchased or a floor
protector can be built from standard materials: two sheets of .5” thick cement board covered with ceramic
tile would be a suitable floor protector which meets the .2 R ‐ value requirement.

When using any floor protector, consider that this stove is not only heavy but will induce heating and
cooling cycles on the floor protector which can damage tile and loosen mortar and grout joints. A hearth
rug is NOT an approved substitute for a proper hearth pad.

For the US and Canada : The floor protector must extend at least 6 in. (152 mm) from the front & sides.

In Canada , it is required that the non ‐ combustible floor protector is underneath and extends 2 in. (50.8
mm.) on either side of any horizontal venting runs AND/OR is directly underneath any vertical venting
pipe.