Wireless Video Door Phone
SECO-LARM U.S.A., Inc.
13
Operating the Wireless Video Door Phone (Continued)
Communicating between Monitors
NOTE:
The Wireless Video Door Phone system can be set up with up to 2 cameras and 3 monitors.
If multiple monitors are set up, then the system can be used as an intercom between each
monitor. To pair additional monitors, see
Pairing Additional Monitors or Cameras
, pg. 14.
Intercom Feature with Two Monitors:
1.
Make sure both monitors are powered ON.
2.
Press the "OK" or "Power" button to turn the monitor's display on.
3.
Press the "OK" button to call the other monitor.
4.
To accept the call, the other monitor's user must press their "OK" button.
5.
Press the "OK" button again when finished with the call.
NOTE:
The intercom feature will automatically timeout after 60 seconds
Intercom Feature with Three Monitors
1.
Make sure all monitors are powered ON.
2.
Press the "OK" or "Power" button to turn the monitor's display on.
NOTE:
Each paired monitor will have an identification number in the top left corner (1, 2, or 3).
3.
Press the "Up" button to call the next highest ID monitor.
4.
Press the "Down" button to call the next lowest ID monitor.
If monitor 1 is calling monitor 2, the user would press the "Up" button.
If monitor 3 is calling monitor 2, the user would press the "Down" button.
If monitor 3 is calling monitor 1, the user would press the "Up" button.
5.
Press the "OK" button when finished with the call.
Resetting the Camera and Pairing a First Monitor
NOTE:
By default, the monitor in the DP-266-1C7Q Complete Kit is paired with the camera. These
instructions apply to resetting the camera and monitor system.
1.
Put the camera into pairing mode:
a.
Remove the camera from the bracket.
b.
If the tamper alarm is active, then the alarm will begin to sound.
i.
Disconnect power from the camera by removing the battery and disconnecting the
power wiring.
ii.
Replace the battery.
c.
Use a paper clip or other small object to press and hold the camera's reset button for three
to four seconds. A single beep indicates the camera is in pairing mode.
NOTE:
The camera will remain in pairing mode for ~15 seconds before automatically exiting.
2.
Pair the first monitor to the camera:
a.
Select "Match code" from the "Pairing" option in the "Settings" menu.
b.
The monitor will display "Success" and the monitor and camera will beep three times.
3.
Reconnect the power wires and return the camera to the bracket.
4.
Press the doorbell button on the camera to confirm the connection.
