Enerzone Solution 1.8, Инструкция по установке и эксплуатации

Страница: 20 / 56

20
Solution 1.8 Installation and Operation Manual
The table below provides a very general indication of the maximum burn cycle times you are likely
to experience, based on firebox volume.
FIREBOX VOLUME
MAXIMUM
BURN TIME
<1.5 cubic feet 3 to 5 hours
1.5 c.f. to 2.0 c.f 5 to 6 hours
2.0 c.f. to 2.5 c.f. 6 to 8 hours
2.5 c.f. to 3.0 c.f. 8 to 9 hours
>3.0 c.f. 9 to 10 hours
Long burn times are not necessarily an indication of efficient stove operation. When you are home
during the day and able to tend the fire, it is preferable to build a smaller fire that might provide
three or four hours of heating than to fully load the firebox for a much longer burn. Shorter burn
cycles make it easier to match the heat output of the stove to the heat demand of the space.
4.3.6.5 North-South Fires Versus East-West Fires
In fireboxes that are roughly square, wood can be loaded so that looking through the glass door
you see the ends of the logs (north-south) or the sides of the logs (east-west).
East-west loads that are built compactly break down slowly when heated, but the amount of wood
you can load is limited because if you put in too many pieces, one may fall against the glass. East-
west loads are excellent for long, low output fires for relatively mild weather.
North-south loads break down more quickly, but much more wood can be loaded at a time. This
makes north-south loading good for high output, long lasting fires for cold weather.
5 Maintaining Your Wood Heating System
5.1 Stove Maintenance
Your new stove will give many years of reliable service if you use and maintain it correctly. Some of
the internal components of the firebox, such as firebricks, baffles and air tubes, will wear over time
under intense heat. You should always replace defective parts with original parts (see
Appendix 8:
Exploded Diagram and Parts List
). For firing each load hot to begin a cycle as described above
will not cause premature deterioration of the stove. However, letting the stove run with the air
control fully open for entire cycles can cause damage over time. The hotter you run the stove
throughout burn cycles, the more quickly its components will deteriorate. For that reason,
never
leave the stove unattended while a new load is being fired hot
.
5.1.1 Plated Finish Maintenance
If your appliance has a plated finish, use a metal polish and a soft cloth to clean it. Do not use
abrasives such as steel wool, steel pads or an abrasive cleaner for they may scratch the finish.
5.1.2 Cleaning Door Glass
Under normal conditions, your door glass should stay relatively clear. If your firewood is dry
enough and you follow the operating instructions in this manual, a whitish, dusty deposit will form
on the inside of the glass after a week or so of use. This is normal and can be easily removed