EnerSys OutBack POWER ALPHA OUTBACK ENERGY GS-IOB-230VAC, Руководство по установке

Страница: 5 / 9

GS-IOB-230VAC Installation lnstructions
Open to 90 degrees
Remove
(x4)
Main
Bracket
lnterior
Cover
Remove (x3)
Remove
(x3)
Figure 3 Removing the Covers and Main Bracket
Once the main bracket has been removed, remove the top four knockouts. lnstall
the circuit breakers and mechanical bypass according to these steps.
1. Place each circuit breaker behind the bracket and orient it so that the
numbers read correctly. Center the device so that the raised area
protrudes through the bracket.
2. Place the red bypass brackets over the screw hol es for the top two
circuit breaker poles. Face the brackets inward as shown in Figure 4.
Align the inner holes on the brackets with those on the circuit breakers.
3. While placing the red brackets, insert the red bypass plate between
them. The tabs on the plate should fit into the slots on the brackets.
NOTE: The plate must be oriented so the hole is on the right. Both
circuit breakers covered by the plate must be in the OFF position.
4. When the bypass mechanism and circuit breakers are in place, insert
screws through the holes in the main bracket. Use the 6-32 x 3/8"
screws that are provided in this kit to secure the breakers with red
brackets. Use the screws previously removed from the circuit breakers
to reattach those not covered by the red brackets.
900-0146-01-00 REV A
5