Enerpac EWCH180, Инструкция

Страница: 13 / 20

13
1
Figure 9, Operation - Advance/Cut
2
Figure 10, Operation - Retract
8.7 Cutting Procedure (typical)
1. Be certain that the properties of the material to be cut
do not exceed the stated maximum limits applicable
to your cutter model. Refer to Section 2.1.
2. Be sure that the piston is in the “home” (fully retracted)
position. See Figure 7.
3. Open the cutting head. Refer to Section 7.2 for
additional information.
4. Place the material into the cutting head and close
the cutting head. Refer to Section 7.2 for additional
information.
5. Place the material to be cut between the fixed and
moving blades. Be sure that it is perpendicular to the
piston axis, as shown in Figure 8. Refer to instructions
in Section 8.5 for additional information.
NOTICE
Failure to properly position the material in
the cutting head may result in blade breakage and
reduced cutting efficiency.
6. Start the pump motor.
7. Press and hold down the advance push buttons until
the item has been fully cut.
8. Press and hold down the retract push buttons until
the moving blade moves fully rearward and is in the
“home” (fully retracted) position.