Enerpac EWCH180, Инструкция

Страница: 17 / 20

17
10.2 Return to Use (after storage)
Before using the cutter after an extended period of
storage or inactivity, perform the following steps:
• Remove protective oil coating (applied before storage)
from cutter surfaces.
• Check for oil leaks. Make repairs as required.
• Check that the tool hydraulic hoses and electrical
cable are intact and undamaged.
• Check for any missing, worn or improperly installed
parts.
• Check that all screws, nuts, bolts and other fasteners
are tight.
• Replace, repair or tighten components as needed.
• Check for proper operation of cutter safety switch.
Cutter must not run unless cutting head is closed,
locking latch is latched and threaded knob is fully
installed.
6. Remove the worn moving blade (Figure 12, item 2).
7. Install new moving blade (Figure 12, item 2) into the
piston.
8. Install the new moving blade screw (Figure 12,
item 1). Torque to 102 ft-lb [138 Nm]. Apply
Loctite 243 or equivalent.
9. Lubricate the slide slot and tool guide in the cutting
head using an NLGI Grade 2 extreme pressure lithium
grease (Figure 12, item 3).
10. Close the cutting head. Refer to Section 7.2 for
additional information.
11. Test for proper operation before placing the cutter
back into service.
10.0 STORAGE
10.1 Storage Guidelines
If the cutter will be stored for an extended period of time:
• Disconnect hydraulic hoses from cutter. Be sure that
dust caps are installed on hydraulic couplers.
• Thoroughly clean the cutter.
• To help prevent corrosion, lubricate the cutter metal
surfaces with a thin layer of oil.
• Store the cutter in a clean and dry place, accessible
only to authorized personnel.
Figure 12, Moving Blade Replacement
1
2
3
Key:
1. Moving Blade Screw
2. Moving Blade
3. Grease Locations