Technical Manual
6
ECO
1. INTRO
1.1 Symbols
Every process that the supplier believes to be conducive to harmful danger and/or
material damage will be signalled with a danger sign.
To better characterize the danger, the symbol will be followed by one of these
words:
[1]
DANGER:
when there is the possibility of harm to the operator and/or
people in the vicinity of the equipment
[2]
WARNING:
when there is the possibility of material damage to the equipment
and/or attached materials.
All the information that the supplier believes to be an asset for better performance
and preservation of the equipment, will be signalled together with the information sign.
1.2 Pre-Installation Information
DANGER
The electrical installation of the equipment must comply with the national regulations
for electrical installations in effect.
ECO
will only operate after receiving its load of refrigerant.
The power supply is 230 V, 50 Hz or 60Hz (version of the equipment produced only
by specific request); and the power supply cable is plugged into a socket with earth
wiring. If the power supply cable is damaged, it must be replaced by the manufacturer,
by its customer service, or by staff with similar training in order to avoid any danger.
ECO
will only operate if the storage water heater is filled with water. Heating of other
fluid than drinking water is not allowed.
1.3 Safety Information
WARNING
DANGER
This appliance is not intended for use by persons (including children) with reduced
physical or mental abilities, or by persons with a lack of experience or knowledge,
unless they have been trained or instructed in the use of the appliance by a person
responsible for your safety;
Children should be supervised to ensure that they do not play with the appliance;
WARNING
DANGER
The minimum water pressure allowed at the entrance to the hydraulic circuit is
0.1MPa.
The maximum allowed water pressure at the entrance of the hydraulic circuit is
0.3MPa.
If the water supply pressure exceeds the rated pressure, a pressure reducing valve
must be installed in the installation.
The installation of the pressure reducing valve must take into account the correct
direction of the hydraulic flow. The correct direction is represented by an arrow on the
component itself. Incorrect installation poses a danger to equipment and people.
