Technical Manual
34
ECO
5 FIRST USE
5.1 Filling the Tank
a) Open a cold water tap / isolation valve next to the safety group (this procedure is also used to
check if the drain valve is closed);
b) After obtaining flow in the hot water tap(s), shut it. Your water heater is full;
c) Check the tightening in the pipes;
d) Carry out successive discharges through the safety valve, in order to guarantee the proper
functioning of all hydraulic components of the installation.
5.2 Start Up of the System
Before starting the
ECO
, check whether the installation is set up according to the recommendations
and that everything is in conformity, then you may plug your equipment to the power supply. After
switching on your equipment, you should wait a few seconds until the controller begins to work.
Then you may start your equipment following these instructions:
1) Startup screen;
2) System is shut off. Press key ON/OFF to turn on the system;
3) Press the key COMP to start up the system;
4) System is running;
5) Setpoint has been reached.
Note 1:
The LED on the ON / OFF button indicates the status of your device. If it is flashing, the
equipment does not have any operating order. If the light is on, your equipment is operating in one of
the available modes.
1
2
3
4
5
