Technical Manual
25
ECO
e) Squeeze the female with your hand, taking a few turns.
It is recommended to use thread sealant, appropriate for the purpose!
The sealant must be placed between these two steps [e); f)].
If in doubt, consult the manufacturer.
f) Give the final tightening by applying a twisting pair of values as indicated in the table;
2
Thermodynamic Panels
a) Prepare the copper pipe, removing the protective caps from the extremities.
b) Place the extremity of the pipe upside down, cut the appropriate size of pipe and sand the
rough edge.
c) Then remove the covers from the panel connections and, using a sharp object, remove 5cm
of heat-shrink tubing from them;
d) Using the appropriate tool, must be made the tube expansion (3/8’’) suitable for connection
to the panel.
WARNING
Diameter of the pipe
(inches)
Applied Torque (Nm)
Wrench Nº
1/4”
14 to 16
19
3/8”
33 to 42
21
1.
2.
3.
5 cm
