Getting
12
Getting started...
ENB539TAS by Energer
Before you start
> Mount the saw blade guard (1) on the riving knifer (2) and align with saw blade teeth.
> Insert the screw (23) through the hole in the saw blade guard (1) and in the riving
knife (2) and secure it with the nut.
> Blade guard MUST be in place.
Assembling the riving knife(Fig. 3-5)
Assembling the saw blade guard(Fig. 6)
Warning: Risk of injury!
The saw blade guard must be in position at all times to prevent
contact with the saw blade. It should lift up and onto the work
piece when the work piece is passed through the saw.
Warning: The blade guard should return to its rest
position after the work piece has been cut.
> Take out the table insert (4) by removing the two cross-head screws (21).
> Slacken the two screws (22), ensuring the plate under the table is not removed,
then insert the riving knife slots under the screw heads.
> Adjust the riving knife (2) so that the gap between the saw blade (15) and the riving
knife (2) equals 3 - 5 mm.
> The riving knife (2) has to be in line with the saw blade (15) in longitudinal direction.
> Retighten the two screws (22).
> The setting of the riving knife has to be checked each time after changing the saw blade.
> Fit the table insert (4) and re-tighten the two cross-head screws (21).
Fig.4
Fig.5
Fig.3 Fig.4
3-5mm
Fig.5
Fig.6
21
22
2
4
15
1
23
2
GB
IE
