Getting
14
Getting started...
Mounting the table saw (Fig. 10-11)
Dust extraction (Fig. 11)
Connection to the power supply
ENB539TAS by Energer
Before you start
The table saw must be properly secured to a sturdy workbench using the two mounting
holes (9) on the saw base.
> Place the table saw over the workbench table top and mark two locations on top of
the workbench by setting the mounting holes at the saw base.
> Drill two mounting holes at the marked location of the workbench.
> Place the table saw on the workbench and align the mounting holes of the table saw
with the drilled holes in the workbench.
> Firmly screw the table saw to the bench surface. “M6” roundhead screws (minimum
40 mm length) or nuts and bolts (M6x40mm) (not provided).
Carefully check the workbench after mounting to make sure that no movement can
occur during use. If any tipping, sliding, or walking is noted, secure the workbench to
the floor before operating.
> Connect the plug with a suitable socket.
WARNING! Check the voltage! The voltage must comply with the information on
the rating label!
> Your product is now ready to be used.
WARNING! Attach a dust extraction device when using
this product in order to keep the working area clean! Wear
a dust mask when operating this product! Dust can be
harmful to health! Especially dust and chips of wood that
has been treated, e.g. with a wood preservative or stain!
Fig. 10
Fig. 11
> The table saw is equipped with dust extraction port (16) / Dia. 24mm for extracting
sawdust and chips.
> Using the extractor adapter, connection to a range of different sawdust extractors
is straightforward.
Fig. 11
9
16
GB
IE
