EN
DURO
®
auto
Steady 39
Ref: AS101FL-UM-TKI-0920-Rev.A
TROUBLE SHOOTING
To prevent the battery from becoming totally discharged during long periods of inactivity it must be
disconnected, fully charged and frost-proof stored.
Please check regularly that the spindle is free of any dirt, or debris that may have been picked up from the road.
Regularly grease spindle and corresponding screw nut. Dirt or corrosion of the
auto
Steady system spindles can
lead to premature shutdown!
Once a year have your
auto
Steady system maintained and visually inspected. This inspection must include all
the bolt/nut connections, the cables and electrical connections and lubrication of movable parts/joints.
In case of any failure or problem, please contact your
EN
DURO
®
auto
Steady
supplier.
Should your
auto
Steady system fail to operate, please check the following:
Unit fails to operate, does not function at all:
Make sure that the battery power isolation switch (24) is turned on.
Check the cable-connection between the caravan battery and the control unit.
Check the fuse in the red positive battery cable (Fig. 15). If the fuse is blown, it must be replaced with a fuse of
the same value (40A). Never “bridge” the fuse (if needed contact your EN
DURO
®
supplier). To replace the fuse,
first disconnect the positive (+) power cable from the battery. Than release the mounting screws that hold the
fuse (Fig. 6A), replace the fuse (Fig. 15B), and finally tighten the screws securely. Close the housing of the fuse
and connect the positive (+) power cable again to the battery. The system is ready again for use.
Check the battery of the remote control. If empty, renew the 9V battery.
Caravan battery could be empty. If empty, recharge completely or renew caravan battery before taking any
further action.
Caravan battery could be overloaded. Check your charging equipment and try to discharge the battery by
connecting/using a light or any other load. If this does not give any result, renew caravan battery before taking
any further action.
Check the distance between the remote control and the caravan is not more than 5 meters. If there is no signal
between the remote control and the control unit, the
auto
Steady system will not function at all and the green
LED on remote control will blink.
Check if there is any distortion signal (other transmitter, high power cables, Wifi etc.) that disturbs a good
communication between remote control and control unit. If there is no good communication between the
control unit and remote control, the
auto
Steady system will not function and the green LED on remote control
will blink.
In general, all error messages will reset automatically after one minute. If this is not the case, reset the
electronics of the
auto
Steady system by switching off the
auto
Steady system via the isolation switch and the
remote control for at least 15 seconds and then turn them on again.
Unit fails to operate or operates intermittently:
Check the battery of the remote control. If empty, renew the 9V battery.
Caravan battery could be empty. If empty, recharge completely or renew caravan battery before taking any
further action.
Caravan battery could be low. Check the voltage drop on the caravan battery, if this drops well below 10 volts,
charge or renew caravan battery
Caravan battery could be overloaded. Check your charging equipment and try to discharge the battery by
connecting/using a light or other load. If this does not give any result, renew caravan battery before taking any
further action.
Check the cable-connection between the caravan battery and the control unit.
Badly connected or corroded battery terminals can cause intermittent problems, check battery terminals, clean
and connect again.
MAINTENANCE