Endress+Hauser SWA70, Руководство по эксплуатации

Страница: 80 / 116

8 Configuration WirelessHART Adapter SWA70
80 Hauser
6. Press Apply to save the settings in the WirelessHART Adapter.
– Press OK to confirm.
– The event is monitored immediately if the WirelessHART Adapter is connected to the
network.
– If the WirelessHART Adapter is not connected to the network, a message appears to this
effect. Press
OK to confirm. The event takes effect when the WirelessHART Adapter joins
the network.
– If the WirelessHART Adapter is not connected to the network, you can also configure event
notification in the offline mode.
Device-specific event mask
parameters Byte Bit Meaning
0 0 No join attempt started so far.
1 The WirelessHART Adapter is not connected to a WirelessHART network.
2 No alternative path to a neighbor.
3 The WirelessHART Adapter does not have a join key.
4 The WirelessHART Adapter could not connect to the WirelessHART network.
1 0 The WirelessHART Adapter could not communicate with a field device.
1 The loop current is less than 2 mA.
2 The loop current exceeds the upper current limit value.
3 Startup voltage was not provided.
4 Operating voltage was not provided.
5 The WirelessHART Adapter is in the configuration mode.
6 The WirelessHART Adapter scans for connected devices.
7 The WirelessHART Adapter has found more than four field devices.
2 0 The hardware of the WirelessHART Adapter is defective.
1 The WirelessHART Adapter is performing a self-test.
2 The temperature of the WirelessHART Adapter is outside the specified range.
3 The hardware of the WirelessHART Adapter is defective.
4 Number of write attempts to FLASH at a critical level.
6 Not used
5 Number of write attempts to FLASH at a maximum level.
7 The hardware of the WirelessHART Adapter is defective.
3 0 The loop current has reached the configured lower warning level.
1 The loop current has reached the configured upper warning level.
2 The loop current has reached the configured lower alarm level.
3 The loop current has reached the configured upper alarm level.
4 Memory (lower part) contains no valid firmware update.
5 Memory (upper part) contains no valid firmware update.
6 There is an entry in the burst table or under event notification without an associated field device.
4 0 First wired device has additional status information.
1 First wired device is not working correctly.
2 Second wired device has additional status information.
3 Second wired device is not working correctly.
4 Third wired device has additional status information.
5 Third wired device is not working correctly.
6 Fourth wired device has additional status information.
7 Fourth wired device is not working correctly.
5 0 - 7 Not used
6 0 Set: the battery unit has energy for less than 30 days and should be changed.
Reset: the battery unit has energy for more than 33 days.
1 One of the device variables is not valid.
2 Failure of power supply unit: field device is no longer powered.
7 0 - 7 Not used