Endress+Hauser Solitrend MMP60, Руководство по эксплуатации

Страница: 5 / 20

Solitrend MMP60 Basic safety instructions
Hauser 5
2.2 Intended use
Application and media
The device described in this manual is intended for the continuous moisture measurement of
a wide variety of materials. Because of its operating frequency of approx. 1 GHz the device can
also be used outside of closed metal vessels.
If operated outside of closed vessels, the device must be mounted in accordance with the
instructions in the Mounting section. The operation of the devices does not present any
health risk. If the limit values specified in the Technical data and the conditions listed in the
instructions and additional documentation are observed, the measuring device may be used
for the following measurements only:
• Measured process variables: material moisture, material conductivity and material
temperature
To ensure that the device remains in proper condition throughout the operating period:
‣
Use the device only for media to which the process-wetted materials are sufficiently
resistant.
‣
Observe the limit values in the "Technical data".
Incorrect use
The manufacturer is not liable for damage caused by improper or non-intended use.
Clarification of borderline cases:
‣
With regard to special fluids and media used for cleaning, the manufacturer is glad to
assist in clarifying the corrosion resistance of materials in contact with the fluid, but does
not accept any warranty or liability.
Residual risks
Due to the transfer of heat from the process and power dissipation within the electronics, the
temperature of the electronics housing and the assemblies contained therein may increase to
up to 70 °C (158 °F) during operation. The device may reach a temperature close to the
medium temperature during operation.
Danger of burns from contact with surfaces!
‣
In the event of high medium temperatures, ensure protection against contact to prevent
burns.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
2.4 Operational safety
Risk of injury!
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The operator is responsible for interference-free operation of the device.