Mounting a
Soliphant FTM 31 DR
with sliding sleeve
Warning!
Risk of injury: The Soliphant can be ejected at high speed from the sliding sleeve if it
is not mounted according to instructions.
It is necessary therefore:
To observe the operating manual enclosed with the sliding sleeve.
Soliphant-
Positioning the cable
entry
If the cable entry is not in the correct position after mounting the Soliphant, then it can
be positioned by turning the housing.
(The cable entry is sealed during shipment by a yellow plastic plug for protection.):
– Open housing cover
– Do not wipe away the lubricant on the thread of the cover or the gasket!
– Place the cover on a clean surface only.
– Loosen the screw in the clamping ring in front of the terminal block by 3 or 4 turns
– Turn the housing until the cable entry is correctly positioned;
when the Soliphant is mounted laterally then the cable entry should point downwards;
the housing can be turned through approx. 270°
– Retighten the screw in the clamping ring on the front of the terminal block
– Close the housing cover
Warning!
FEM
..
FEM
..
3...4 x
Cable entry
Cable entry
B
A
175
Y12
Fig. 12
Position cable entry
3 Installation
FTM 30 DR, FTM 31 DR, FTM 32 DR
16
Hauser
