Prothermo NMT 538
Hauser Systems & Gauging
25
QOC1:Quick operation guide for setting an access code
5.1.4
Type of the Programming Matrix group
The row 0…3 of the programming matrix are called "Static Matrix". Its functionality is to display
and allow programming of mainly measured value (primary variables) and basic operation of the
Proservo NMS53x and NMT538.
The row 4…9 exist on 9 different pages called as "Dynamic Matrix". These matrix groups are
labeled as follows.
G1: CALIBRATION
G2: DEVICE DATA
G3: SERVICE
G4: TEMPERATURE
G5: HART DEVICE (1)
G6: HART DEVICE (2)
G7: ADJUST SENSOR
G8: TANK PROFILE (NMS software ver. 4.25 only)
G9: INTERFACE PROFILE (NMS software ver. 4.25 only)
1120.0mm BAL
MEASURED VALUE 1
MORE FUNCTION
MORE FUNCTION
0
51
EDITING ENABLED
65.5c : LIQU: E
>GROUP SELECT<: E
>GROUP SELECT<: E
>GROUP SELECT<: E
ACCESS CODE
ACCESS CODE
Hold "E" key for more than 3sec.
Enter "+" key 3 times
Home position display
Now you are in the
G0 Static matrix
Note!
If you missed "MORE FUNCTION"
matrix, use "-" key to reverse.
If you missed "ACCESS
CODE" matrix, keep entering
with "E" till next cycle.
Other than 50, 51, or 777, display
will reply "EDITING BLOCKED",
correct code must be entered.
Access code confirmed
Now, it is ready for
further configuration
Enter "E" key several times until
"ACCESS CODE" will appear
on the display.
Use "+" or "-" to set
desired access code (50, 51, 777)
Enter "E" to confirm, Access code
is now acquired.
Then, Enter "E" once to return
to "MORE FUNCTION"
in Static matrix
LCD display
Procedure
Remark
5 Operation with the Proservo NMS53x
