Endress+Hauser prosonic flow 92, Руководство по эксплуатации

Страница: 68 / 98

11 Description of device functions Prosonic Flow 92
68 EHauser
11.3.1 Group SITE SETUP
Site Setup
Þ
Parameter Memory
Þ
Function
Þ
Site Data
Þ
Function
Þ
Zeropoint Adjust
Þ
Function
Þ
Time Constant
Þ
Function
Þ
Adjustment
Þ
Function
Þ
Low Flow Cut-Off
Þ
Function
Þ
Totalizer
Þ
Function
Site Setup
Site Setup Parameter Memory
The function group “PARAMETER MEMORY” serves for entry and recovery of all site data and assists
during commissioning of the measurement.
Mode (Parameter
Memory) Use this function to select the operating mode of the parameter memory:
Options:
SAVE – LOAD – DELETE
The selection of operating mode is used to operate the respective function in
the selection table “NO. / SITE NAME” which is displayed at the bottom sec-
tion of the screen. Change to the selection table after selecting the operating
mode by means of the
W
key and enable the desired data set by pressing
“ENT”.
SAVE
A data set of Site Setup data is saved by selecting the desired No. in the
selection table by means of the
W
and
V
keys and consecutively pressing
the “ENT” key once. Herewith the set of site date which has been defined in
the function group “SITE DATA” will be stored at the number selected.
Caution!
If a different name is already displayed in the column “SITE NAME”, the
number in question is occupied with a set of site data. Executing the com-
mand “SAVE” will overwrite the existing set of data.
LOAD
The operating mode “LOAD” calls up an already existing set of site data
which is stored in the parameter memory. The data are automatically trans-
ferred and loaded into the function group “SITE DATA” and enabled for use.
The name of the data set selected is displayed in the field “LOAD NAME”.
DELETE
Caution!
The selected data set with site data will be erased irreversibly from the data
memory when performing the selection described next.
Deleting the definition and parameters of a specific measurement site is per-
formed through selecting the respective set of data in the selection table by
means of the
W
and
V
keys and consecutively pressing the “ENT” key
once.
Factory setting:
SAVE