Endress+Hauser Proline Prowirl F 200, Руководство по эксплуатации

Страница: 109 / 224

Proline Prowirl F 200 PROFIBUS PA Commissioning
Hauser 109
Parameter Prerequisite Description Selection / User
entry
Factory setting
Assign status • The Switch option is
selected in the Operating
mode parameter.
• The Status option is
selected in the Switch
output function parameter.
Select device status for switch
output. • Low flow cut off
• Digital output 2 Low flow cut off
Switch-on value • In the Operating mode
parameter, the Switch
option is selected.
• In the Switch output
function parameter, the
Limit option is selected.
Enter measured value for the
switch-on point. Signed floating-point
number Country-specific:
• 0 m³/h
• 0 ft³/h
Switch-off value • In the Operating mode
parameter, the Switch
option is selected.
• In the Switch output
function parameter, the
Limit option is selected.
Enter measured value for the
switch-off point. Signed floating-point
number Country-specific:
• 0 m³/h
• 0 ft³/h
Switch-on delay • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Define delay for the switch-on
of status output. 0.0 to 100.0 s 0.0 s
Switch-off delay • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Define delay for the switch-off
of status output. 0.0 to 100.0 s 0.0 s
Failure mode – Define output behavior in
alarm condition. • Actual status
• Open
• Closed Open
Invert output signal – Invert the output signal. • No
• Yes No
* Visibility depends on order options or device settings
10.5.5 Configuring the totalizer
In the "Totalizer 1 to n" submenu the individual totalizer can be configured.
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to n
‣
Totalizer 1 to n
Assign process variable →  110
Unit totalizer →  110
Control Totalizer 1 to n
→  110
Totalizer operation mode →  110
Failure mode →  110