Endress+Hauser Memosens CFS51, Руководство по эксплуатации

Страница: 13 / 44

Memosens CFS51 Mounting
Hauser 13
2.
1 2
A0048146
1 Optical window
2 Joint of the clamping ring
Slide the clamping ring through the sensor from below.
3. Align the joint of the clamping ring perpendicularly to the optical window of the
sensor.
4. Slide the clamping ring exactly onto the horizontal alignment lines.
5. Using the enclosed M5 screw, secure the clamping ring with a torque of 5 Nm.
Installation without flow assembly
80 (3.15)
A0049306
 9 Positioning the sensor. Dimensions: mm (in)
Please note the following when installing the sensor without a flow assembly:
• The immersion depth of the sensor must be selected in such a way that the optical
window of the sensor is always fully immersed in the medium.
• The distance to the bottom of the vessel must be at least 80 mm (3.15 in).
5.1.3 Orientation
The angle of inclination of the sensor can affect the formation of air bubbles below the
sensor. The greater the angle of inclination of the sensor, the more insensitive the
measurement is to air bubbles.
‣
Adjust the angle of inclination if many air bubbles form →  13.
Setting the angle of inclination of the sensor
Depending on the measuring point, the angle of inclination for the sensor can be set
individually. The angle of inclination is determined by the location of the spacer on the
panel →  5,  11.