Endress+Hauser Fieldgate FXA520, Руководство по эксплуатации

Страница: 54 / 108

5 Commissioning Fieldgate FXA520
52 Hauser
5.6 Mail Settings
Mail
allows you to configure e-mails and SMSs to be sent on an event or alarm.
5.6.1 Mail Setup
Procedure
1 If not already active, press
Switch to Administration Mode => Settings => Mail
– Scroll down to reveal the
Mail Setup
page.
– Enter your settings and confirm with "
Send
".
2 After the parameters downloaded to the Fieldgate a test measurement e-mail is sent to the
address defined.
3 Now scroll down to the
Message Text
dialog and enter the message to be used in the mail
– Enter your settings and confirm with "
Send
".
Mail setup
Parameter Description
SMTP Gateway
Enter the IP address or URL of your e-mail server here.
– Normally not required for GRPS; may have a limited period of validity
SMTP User Name
If authentication is required for the specified SMTP Gateway, enter the user name here
– Leave blank if no authentication is requested or no SMTP Gateway is used
SMTP Password
If authentication is required for the specified SMTP Gateway, enter the password here
– Leave blank if no authentication is requested or no SMTP Gateway is used
Sender Address
Enter the sender address of the Fieldgate here, e.g. fieldgate@company.co.uk.
– With some providers, the e-mail address of the account holder must be specified as the
sender address. No mails will be accepted from other sender addresses.
– Where the sender address is freely selectable, choose a serious address to avoid trouble
with spam filters
Address Service Alarm
Mails
Enter the recipient of the serv ice alarm mails here, e.g. name@company.co.uk.
Address Limit Alarm Mails
Enter the recipient of the limit alarm mails here, e.g. name@company.co.uk.
– Alarm notifications are sent in accordance with the settings made in the "E-Mail on
Alarm" column of the device details page, see Chapter 6.4.
Remind pre-Boot Limit
Alarms
Check this box to stop the Fieldgate sending measurement mails when it is restarted with
after being powered down.
Address Measurement
Mails
Enter the recipient of the measurement mails here, e.g. name@company.co.uk.
– Measurement notifications are sent in accordance with the settings of the parameters
below
Periodic Measurement
Mails
Select period for sending mails from dropdown menu
Format Measurement Mails
Select format for sending mails from dropdown menu
– XML is required if the e-mails are to evaluated by the Fieldgate Data Access software
and/or SupplyCare
Data Logging Email on
(Visible only when DAT
module installed in Fieldgate)
Check the box to to send an e-mail when:
– Periodic measurement mail
– Log buffer full
– Device event