Description of parameters
Cerabar S 4 to 20mA HART
26
Hauser
DIP STATUS (363)
Display
Displays the status of DIP switch 1 on the electronic insert.
You can lock or unlock parameters relevant to the measured value with DIP switch 1.
If operation is locked by means of the INSERT PIN No. parameter, you can only unlock
operation again by means of this parameter. (
INSERT PIN NO, see Page 32.)
See also Operating Instructions BA00412P, "Locking/unlocking operation".
Display:
• On (locking switched on)
• Off (locking switched off)
Factory setting:
Off (locking switched off)
Table 10: (GROUP SELECTION
) OPERATING MENU
TRANSMITTER INFO
PROCESS CONNECTION
Parameter name
Description
Pmax PROC. CONN. (570)
Entry
For entering and displaying the maximum permitted pressure of the process connection.
Factory setting:
as per nameplate data (
see also Operating Instructions BA00412P,
Section "Nameplate")
PROC. CONN. TYPE (482)
Options
For selecting and displaying the process connection type.
Options:
• Not used
• Unknown
• Special
• Oval flange
• Thread female
• Thread male
• Flange
• Remote seal
MAT. PROC. CONN. +
(360)
Options
For selecting and displaying the material of the process connection (P+).
See also parameter description for MAT. PROC. CONN. -
Options:
• Not used
• Unknown
• Special
• Steel
• 304 st. steel
• 316 st. steel
• Alloy C
• Monel
• Tantalum
• Titanium
• PTFE (Teflon)
• 316L st. steel
• PVC
• Inconel
• PVDF
• ECTFE
Factory setting:
As per order specifications
Table 9: (GROUP SELECTION
) OPERATING MENU
TRANSMITTER INFO
TRANSMITTER DATA
Parameter name
Description
