Assembly of aluminum profile (B1) and
extrusion assembly (E). Aluminum profile (B1) is
shown in the diagram on the left(1). Pay attention to
the position and direction of the large hole. Align the
hole of extrusion assembly (E) with the threaded
hole of aluminum profile (B1), it should be noted
that the hole has two plates, which aresecured with
M4*16 screws, and fixed to the second profile plate
and the aluminum profile (B1). Use the Allen key to
tighten the screws.
Adjust the direction of the nozzle kit(N) as
shown in Figure (3). Hold one end of the timing belt
in the slot on the right side underneath the nozzle
kit (N), and the other end in the path shown in
Figure (2). Go through the extrusion assembly (E),
bypass the synchronizing wheel, and slide the nozzle
kit (N) from the left into the aluminum profile when
the path of figure (2) completes three quarters (in
the red line position in Figure 2). Then, complete the
path of the belt as shown in Figure (2). Then, stick
the other end of the belt to the slot on the left side
below the nozzle kit (N).
Position the pulley assembly (K2) in the
position shown in Figure (3), align the threaded hole
in the aluminum profile on the left side of the profile
(B1), pass it with the M4*16 screw, and use the Allen
key to tighten the screws.
As you complete easy step, be sure to place
the parts according to the diagram on the left side.
7