A.
Connect the motor wires of the four XYZE axes in sequence according to the wire markings;
B.
Connect the limit switch wires for the XYZ axes in sequence according to the wire markings;
C.
Plug the color flat cable into the back of the display;
D.
Connect the connector between the power supply and the motherboard.
Note: Adjust the voltage properly according to your region before plugging in the power cord, and turn
on the machine only after the voltage is correct.
Note: Remove the material before leveling (ignore if no consumables are loaded) to ensure that the
nozzle is free of residue, and then restore the factory settings (reset all parameter values). (Assembe
(Installation) & Tutorial Video : watch it in the Assembe (Installation) & Tutorial Video
→
folder of the supplied
in the data
memory card)
Install wires
6 Auto Leveling
1.
Click the knob to enter the Main interface: first enter Configuration menu →Restore Defaults, and then back
to Main menu and enter Motion menu → click Level Bed
Default: the printer automatically returns to the home position for auto-calibration of 16 points, and return to
the home position again, and then the levelling is complete.
2.
Enter Main menu → click Motion → click Probe Z Offset → adjust Probe Z Offset, make sure the distance
between nozzle and platform is about the thickness of an A4 she
et of paper → click Store Settings
3.
Z axis height may be adjusted according to printing effect during the printing: enter Main menu → Tune →
Probe Z Offset → adjust the Z-axis height to optimum effect based on situations → back to previous
interface and click Store Settings
Auto leveling, no installation
needed
Info Screen
Motion
Temperature
Con
figur
ation
Change Filament
Info Screen
Motion
Temperature
Con
figur
ation
Change Filament
Preheat PLA Conf
Preheat ABS Conf
Store Settings
Load Settings
Restore Defaults
Probe Z Offset
:
-0.04
-0.02
0.00
0.02
0.04
Preheat PLA Conf
Preheat ABS Conf
Store Settings
Load Settings
Restore Defaults
Probe Z Offset
:
-0.04
-0.02
0.00
0.02
0.04
Info Screen
Motion
Temperature
Confi
guration
Change Filament
Main
Move Axis
Auto Home
Level Bed
Probl
e Z Off
set
Main
Move Axis
Auto Home
Level Bed
Prob
le Z Off
set
Info Screen
Pause Print
Stop Print
Tune
About Printer
Bed:
50
0%
100
Fan Speed:
Flow:
Prob
e Z Off
set
Store Settings
Bed:
50
0%
100
Fan Speed:
Flow:
Probe Z O
ff
set
Store Settings
