10
MIC
Previous
Record
Next
Mode
Erase
i.d. mate SUMMIT keypad
version. Then, you will hear “i.d. Mode” along with a beep signaling the scanner
powering on. When i.d. mate SUMMIT
®
is turned on, it will always begin in i.d. Mode.
Behind the AC/DC jack and the thumbwheel you will find a loop which is to be used to
attach your padded neck strap.
OK. Let’s move to the back of the device where you’ll find an opening in the rubber
enclosure revealing your Model and Serial Number label and two narrow slits to
accommodate the wrist / arm strap accessory.
To access your battery, gently peel the rubber enclosure around the front lip of the
scan window and push or pull the plastic case out. The battery compartment door is
located on the rear with the model / serial number label attached to it. To open, push
the latch down and pull the lid out to expose the battery pack. To replace the lid,
insert the end opposite the latch first and push the lid closed until you hear a click.
After inspection, slide the rubber enclosure to its original position
around the plastic case.
Now, on the front of the recorder there are five buttons. The first
button on the left hand side is a 3/4 inch long rectangular shaped
button. This is the mode button. It is the most frequently used
button on the unit. As the name implies, the mode button is used to
place the recorder into the mode of operation you want to use.
The recorder unit has four (4) standard modes of operation; they
are: i.d. Mode (the mode in which the bar code scanner is
used), Memo Mode, System Mode, and Help Mode. When
enabled, the additional modes of Bar Code ID, Inventory Mode, and Browse Inventory
Mode will follow i.d. Mode when cycling through the different modes.
