EMS TAM-242, Инструкция по установке и эксплуатации

Страница: 15 / 23

TAM-242/252/262 Installation and Operating Manual Installation
This document contains information that is proprietary and confidential to EMS Global Tracking (one or more of the following: EMS Global Tracking Ltd and EMS Technologies
Canada, Ltd), and is supplied on the express condition that it is not to be used for any purpose other than the purpose for which it was issued, nor is it to be copied or
communicated in whole or in part, to any third party other than the recipient organization, without the prior written permission of EMS Global Tracking.
MAN-0059 Issue 4 © 2011 EMS Global Tracking Ltd, EMS Technologies Canada Ltd. 9 of 17
Key Switch Operation
The key switch is used to turn the TAM-242 on or off for periods when the equipment is not in use
and thus preserve battery life.
Switching On the Terminal
Turn the key switch to the on position. When switching the terminal on, the LED will start to flash 1
second on, 2 seconds off until a position report has been sent or it has timed out (up to 10 minutes).
Figure 3-3: Key Switch On Position
Note: If the LED does not switch on as expected there may be a fault. Please refer to
Troubleshooting on page 11 for more information.
Switching Off the Terminal
Turn the key switch to the off position. The LED will switch on for 6 seconds then switch off. The
terminal is now in the off state and will not transmit position reports until switched back on.
Figure 3-4: Key Switch Off Position
Note: If the LED does not switch on as expected there may be a fault. Please refer to
Troubleshooting on page 11 for more information.