EMS TAM-242, Инструкция по установке и эксплуатации

Страница: 13 / 23

TAM-242/252/262 Installation and Operating Manual Installation
This document contains information that is proprietary and confidential to EMS Global Tracking (one or more of the following: EMS Global Tracking Ltd and EMS Technologies
Canada, Ltd), and is supplied on the express condition that it is not to be used for any purpose other than the purpose for which it was issued, nor is it to be copied or
communicated in whole or in part, to any third party other than the recipient organization, without the prior written permission of EMS Global Tracking.
MAN-0059 Issue 4 © 2011 EMS Global Tracking Ltd, EMS Technologies Canada Ltd. 7 of 17

For installations exposed to shock and/or vibration, use a mounting scheme that isolates
the unit from the excessive shock and/or vibration.

Choose a location that is not near other satellite communication equipment, and/or
microwave dishes to prevent RF jamming.

It is advisable to leave at least a 1 meter separation between the system and any other
communications devices.

Avoid mounting on a hot surface.
Figure 3-1: Inmarsat Satellite Constellation
Mounting
Caution: The TAM-242 must be mounted so that the key switch and connector side of the TAM-242
is facing in the opposite direction to the direction of travel of the asset being tracked.
The mounting position should take into account the criteria defined in Location on page 6. If the
terminal is to be permanently fitted then all four mounting points must be use. The four mounting
points are M4 clearance holes on a 230.3mm x 161.3mm rectangle, with the enclosure overhanging
these fixings by around 10mm on all sides. Fit the adhesive pads to the face of each magnet to
protect against damage to the asset.
Caution: Do not over tighten the fixing points, doing so may cause damage to the TAM-242.