30786-7-0415
Page 60
Wiring
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with
the
National Electrical Code, ANSI/NFPA 70
, if an external electrical
source is utilized.
this appliance is equipped with a three-prong
[grounding] plug for your protection against shock hazard
and should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the grounding
prong from this plug.
For an ungrounded receptacle, an adapter,
which has two prongs and a wire for grounding, can be purchased,
plugged into the ungrounded receptacle and its wire connected
to the receptacle mounting screw. With this wire completing the
ground, the appliance cord plug can be plugged into the adapter
and be electrically grounded.
cAUtiOn:
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
Blower Motor
The blower motor does not have oiling holes. Do not attempt to oil
the blower motor.
Blower Wheels
The blower wheels will collect lint and could require periodic cleaning.
If the air output decreases or the noise level increases, it indicates a
dirty blower wheel. Remove blower and clean blower wheels.
WArninG:
Unplugging of blower accessory will not stop the heater
from cycling. to turn off gas to the unvented heater: push
in gas control knob slightly and turn clockwise to “OFF.”
Do not force.
Figure 74
OptiOnAL BLOWer instALLAtiOn instrUctiOns (continued)
Figure 75
1
FBB5
BLOWER ASSEMBLY COMPLETE
2
R9901
FAN CONTROL SWITCH
1
2
A
B
110 VOLT AC
JUNCTION BOX
WHITE
FAN
SWITCH
BLACK
FAN/MOTOR
ASSEMBLY
