Page 19
SPCL36104-S Suction System
7.11.2
The “MAIN” screen is now displayed, from here
you can either adjust the “PART SETUP”
parameters, go to the “PROCESS MONITOR”
screen to see where in the cycle the system is
currently at, switch to the “MAINTENANCE”
screens to perform additional setup configurations or
manual operate the machine, or check the overall
“SYSTEM STATUS” of the inputs, outputs, and
faults.
7.11.3
PART SETUP
Pressing the “PART SETUP” button on the “MAIN”
screen, brings up the basic setup screen where the
operator enters the “PART DIAMETER” and the
“PART LENGTH” for the next cycle. Pressing in
the
orange field or the corresponding soft-touch function
key will bring up a numeric entry panel. Here the
desired value is entered.
If the length of the part to be run is shorter then the
previously run part, the “PINCH OSCILLATOR”
will have automatically repositioned itself. In the
event that the new part to be run is Longer than the previous part, the oscillator will need to be
reset by either pressing the “F7” button or the “reset” button on the screen.
Once the parameters are correct and the oscillator is in the correct position, the operator then
needs to acknowledge that the Part Setup is Complete by pressing the “YES” button or “F8”.
Movement from this screen to other screens is done by pressing the desired button on the
screen or their corresponding function key.
The current Cycle Status is also displayed on this SETUP SCREEN.
7.11.4
PROCESS MONITOR
This screen displays the current setup parameters
and the process variables at the current point in the
operation cycle.
The current “CYCLE STATUS” is also shown on
this display.
Movment between screens is again performed by
touching the desired button of pressing the desired
function key.
7.11.5
MAINTENANCE SCREEN
