34846-2-1016
Page 2
BEFORE YOU START
1. Read the soot prevention information on
page 4.
2. Read the safety information on
pages 9 - 11.
3. Frame the opening.
See pages 23 - 24.
4. Install the gas lines.
See page 19.
5. Install the wiring.
See pages 32 and 44.
6. Install the remote system.
See pages 37 - 42.
7. Light the fireplace and troubleshoot.
See pages 29, 30, 36, 46 and 47.
8. Show the homeowner how to operate the fireplace.
9. Show the homeowner how to do the basic maintenance.
Unpacking the fireplace
1. Cut binding straps and shrink wrap.
2. Remove top of carton.
3. Remove glass carton from back of unit and set aside.
4. Remove non-combustible board and set aside.
5. Remove remaining carton.
6. Verify that the fireplace and components have not been
damaged during shipping.
7. Set fireplace in a location near to its final installation location.
Installation Considerations - Fireplace Installation
Guidelines
In planning the installation for the fireplace, determine where the
unit is to be installed. The fireplace can be mounted on any of
these surfaces:
1. A flat hard combustible or non-combustible surface.
2. A raised platform of combustible or non-combustible
material.
3. Four corners of the fireplace so contact is made on all four
perimeter edges on the bottom of the unit.
If the fireplace is installed directly on carpeting, tile or other
combustible material other than wood flooring, it should be
installed on a metal or wood panel extending the full width and
depth of the unit.
This unit is designed to be installed in a zero-clearance
enclosure. This means the combustible material can come in
contact with the top and side standoff spacers, and secured to
combustible framing using the framing brackets provided.
An optional
(Inner Top Deflector)
is included with the fireplace.
This can be used to help distribute the heat of the fireplace
more evenly across the fireplace opening. This does not change
the requirements for non-combustible material above the
fireplace opening.
It is also necessary to determine the following before installation:
•
Any desired accessory
•
Gas supply piping (left side entrance).
•
Electrical connections - for optional light kit
•
Electrical supply requirements for optional light.
(120V, 60Hz, 1 Amp) (right side entrance)
•
Proper opening size of fireplace required for installation of
the fireplace insert.